">

Click here to check out our new How To section">Click here to check out our new How To section
Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 57 Next »

Editing the Rotation on Outsides

 Rotation Definition

The Rotation controls for Swoops and Flares in Non-Oval Objects.

 Swoop Definition

A Swoop in a Non-Oval Opening is where the corners Curve Inward toward the opening.

The Rotation controls for Swoops and Flares in Non-Oval Openings.

If the Non-Oval Opening has a Swoop, Increase the Rotation.

 Flare Definition

A Flare in a Non-Oval Opening is where the corners Curve Away from the opening.

The Rotation controls for Swoops and Flares in Non-Oval Openings.

If the Non-Oval Opening cuts with a Flare, Decrease the Rotation.

 How to Select the Bevel Type to Edit

Select desired Cartridge Tab. 

Select the desired Bevel Type from Current Bevel Type.

Edit the desired Configuration field.

 When Cutting from the Front

Select Current Bevel Type-Front of Mat when cutting from the front of the mat.

*The different Opening Bevel Types, including whether it is cutting from the Front or Back, controls the cut direction of the Head, and determines whether the cut is a Backup or an Overcut.

 How to Adjust the Rotation

When adjusting Configurations, click the Plus (Increase) or Minus (Decrease) button on the desired field about five times.

Click OK and do another test cut.

Continue making adjustments until the desired outcome is achieved.

Outside has a Swoop

Problem:

  • Non-Oval Outside has a Swoop.

Resolution:

 Swoop Definition

A Swoop in a Non-Oval Opening is where the corners Curve Inward toward the opening.

The Rotation controls for Swoops and Flares in Non-Oval Openings.

If the Non-Oval Opening has a Swoop, Increase the Rotation.

Outside has a Flare

Problem:

  • Non-Oval Outside has a Flare.

Resolution:

 Flare Definition

A Flare in a Non-Oval Opening is where the corners Curve Away from the opening.

The Rotation controls for Swoops and Flares in Non-Oval Openings.

If the Non-Oval Opening cuts with a Flare, Decrease the Rotation.

Twisted Corner

Problem:

  • A Twisted Corner is when the blade turns before retracting from the matboard, which tears the matboard and twists the corner.

  • This is especially visible from the back of the mat.

Resolution:

  1. Check to make sure the Rotation hasn't been set to a high number. 

  2. Twisted corners can also be a symptom of oil/water in the Air Valve, or an issue with the Head.

  3. Check the Air Regulator for excess water.

  4. Use the Clean the Foot Block procedure for cleaning the foot block. 

  • No labels