">

Click here to check out our new How To section">Click here to check out our new How To section
Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 34 Next »

Cartridges Involved

This Configuration element involves the following Cartridges.

Note: Not all cartridges are available for all CMC models.

Interior Backup on the Outsides Definition

Adjusting the Interior Backup

  • To adjust, click Plus/Minus on the desired field about five times.

  • Click OK and do another test cut.

  • Continue making adjustments until the desired outcome is achieved.

 Interior Backup Definition

The Interior Backup controls where the Blade Plunges into the Fallout (not the Matboard) on the Interior cuts.

Current Outside Bevel Type

The different Bevel Types, including whether it is cutting from the front or the back of the mat, will determine the direction the head travels as it cuts, and dictates whether the corner is a backup or an overcut.

  • Outside

  • Outside-Front of Mat

Outside Interior Backup Too Long

Problem:

  • The Interior Backup cuts Too Long.

Resolution:

 Interior Backup Definition

The Interior Backup controls where the Blade Plunges into the Fallout (not the Matboard) on the Interior cuts.

Outside Interior Backup Too Short

Problem:

  • The Interior Backup cuts Too Short.

Resolution:

 Interior Backup Definition

The Interior Backup controls where the Blade Plunges into the Fallout (not the Matboard) on the Interior cuts.

  • No labels