">

Click here to check out our new How To section">Click here to check out our new How To section
Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 46 Next »

Cartridges Involved

This Configuration element involves the following Cartridges.

Note: Not all cartridges are available for all CMC models.

Rotation on Outsides Definition

 Rotation Definition

The Rotation controls for Swoops and Flares in Non-Oval Objects.

 Swoop Definition

A Swoop in a Non-Oval Opening is where the corners Curve Inward toward the opening.

The Rotation controls for Swoops and Flares in Non-Oval Openings.

If the Non-Oval Opening has a Swoop, Increase the Rotation.

 Flare Definition

A Flare in a Non-Oval Opening is where the corners Curve Away from the opening.

The Rotation controls for Swoops and Flares in Non-Oval Openings.

If the Non-Oval Opening cuts with a Flare, Decrease the Rotation.

Adjusting the Rotation

  • To adjust, click Plus/Minus on the desired field about five times.

  • Click OK and do another test cut.

  • Continue making adjustments until the desired outcome is achieved.

Current Bevel Type

Outside has a Swoop

Problem:

  • Non-Oval Outside has a Swoop.

Resolution:

  • Non-Oval Outside has a Swoop:

 Swoop Definition

A Swoop in a Non-Oval Opening is where the corners Curve Inward toward the opening.

The Rotation controls for Swoops and Flares in Non-Oval Openings.

If the Non-Oval Opening has a Swoop, Increase the Rotation.

Outside has a Flare

Problem:

  • Non-Oval Outside has a Flare.

Resolution:

  • Non-Oval Outside has a Flare, Decrease the Rotation.

 Flare Definition

A Flare in a Non-Oval Opening is where the corners Curve Away from the opening.

The Rotation controls for Swoops and Flares in Non-Oval Openings.

If the Non-Oval Opening cuts with a Flare, Decrease the Rotation.

Twisted Corner

Problem:

  • A Twisted Corner is when the blade turns before retracting from the matboard, which tears the matboard and twists the corner.

  • This is especially visible from the back of the mat.

Resolution:

  1. Check to make sure the Rotation hasn't been set to a high number. 

  2. Twisted corners can also be a symptom of oil/water in the Air Valve, or an issue with the Head.

  3. Check the Air Regulator for excess water.

  4. Use the Clean the Foot Block procedure for cleaning the foot block. 

  • No labels