">

Click here to check out our new How To section">Click here to check out our new How To section
Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 32 Next »

Cartridges Involved

This Configuration element involves the following Cartridges.

Note: Not all cartridges are available for all CMC models.

Exterior Overcut on Creases Definition

Adjusting the Exterior Overcut

  • To adjust, click plus/minus on the desired field about five times.

  • Click OK and do another test cut.

  • Continue making adjustments until the desired outcome is achieved.

 Exterior Overcut Definition

The Exterior Overcut controls where the blade retracts from the matboard on exterior cuts.

Current Crease Bevel Type

  • Crease

Crease Exterior Overcut Too Long

Problem:

  • The Exterior Overcut is applied Too Long.

Resolution:

 Exterior Overcut Definition

The Exterior Overcut controls where the blade retracts from the matboard on exterior cuts.

Crease Exterior Overcut Too Short

Problem:

  • The Exterior Overcut is applied Too Short.

Resolution:

 Exterior Overcut Definition

The Exterior Overcut controls where the blade retracts from the matboard on exterior cuts.

  • No labels