">
Skip to end of metadata
Go to start of metadata

You are viewing an old version of this content. View the current version.

Compare with Current View Version History

« Previous Version 17 Next »

Cartridges Involved

This Configuration element involves the following Cartridges.

Note: Not all cartridges are available for all CMC models.

Vertical Adjustment for Non-Blade Cartridges Definition

Select the Tool and Type

Tool Line Too Far Up

Problem:

  • The tool line is applied too far up vertically.

 Vertical Adjustment Definition

The Vertical Adjustment controls specifically where the tool is placed Vertically.

Resolution:

  • To adjust, click plus/minus on the field about five times.

  • Click OK and do another test cut.

  • Continue making adjustments until the desired outcome is achieved.

Tool Line Too Far Down

Problem:

  • The tool line is applied too far down Vertically.

 Vertical Adjustment Definition

The Vertical Adjustment controls specifically where the tool is placed Vertically.

Resolution:

  • To adjust, click plus/minus on the field about five times.

  • Click OK and do another test cut.

  • Continue making adjustments until the desired outcome is achieved.

See Also: Opening Cuts in the Wrong Place Vertically when not cutting the Outside

Problem:

  • The opening cuts in the wrong place Vertically.

 Vertical Home Definition

The Vertical Home controls specifically where the opening is cut Vertically.

Resolution:

  • If too far down, increase the Vertical Home.

  • If too far up, decrease the Vertical Home.

  • See Vertical Home for additional information.

  • No labels