">

Click here to check out our new How To section">Click here to check out our new How To section
Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 15 Next »

Cartridges Involved

This Configuration element involves the following Cartridges.

Note: Not all cartridges are available for all CMC models.

Tool Configs Section

The Tool Configs on the Configurations Screen displays the global settings for the bevel cartridge tabs. 

Horizontal 

Problem:

  • The opening/object is cut in the wrong place Horizontally.

Resolution:

  • If too far left, increase the Horizontal Home.

  • If too far right, decrease the Horizontal Home.

  • See Horizontal Home for additional information.

Vertical 

Problem:

  • The opening/object is cut in the wrong place Vertically.

Resolution:

  • If too far down, increase the Vertical Home.

  • If too far up, decrease the Vertical Home.

  • See Vertical Home for additional information.

 

Depth Bias 

Problem:

  • The opening/object is cut at the wrong depth when a SKU has been selected.

Resolution:

  • Cut too shallow, increase the Depth Bias.

  • Cut too deep, decrease the Depth Bias.

  • See Depth Bias for additional information.

Plunge Count 

Problem:

  • The opening/object does not pause for a blade change while cutting.

Resolution:

  • If cuts too long before pausing, decrease the Plunge Count.

  • If cuts too short before pausing, increase the Plunge Count.

  • See Plunge Count for additional information.

Circle/Oval Rotation Button

Problem:

  • The Circle/Oval cuts with a Feather/Bump.

Resolution:

  • If cuts with a Feather, decrease the Oval Rotation.

  • If it cuts with a Bump, increase the Oval Rotation.

  • See Circle/Oval Rotation Utility for additional information.

  • See Oval Rotation for additional information.

  • No labels