">
Skip to end of metadata
Go to start of metadata

You are viewing an old version of this content. View the current version.

Compare with Current View Version History

« Previous Version 12 Next »

Cartridges Involved

This Configuration element involves the following Cartridges.

Note: Not all cartridges are available for all CMC models.

Vertical Adjustment for Non-Blade Cartridges Definition

The Vertical Adjustment controls where the Tool (Deboss, Pen or Vinyl) is applied Vertically.

Select the Tool and Type

Tool Line Too Far Up

Problem:

  • The tool line is applied too far up vertically.

Resolution:

When making adjustments, click the plus or minus button at the end of the desired field about five times.

Click OK and do another test cut.

Check the results of the cut and continue making adjustments until the desired outcome is achieved.

Tool Line Too Far Down

Problem:

  • The tool line is applied too far down Vertically.

Resolution:

When making adjustments, click the plus or minus button at the end of the desired field about five times.

Click OK and do another test cut.

Check the results of the cut and continue making adjustments until the desired outcome is achieved.

Opening Cuts in the Wrong Place Vertically when not cutting the Outside

Problem:

  • The opening cuts in the wrong place Vertically.

Resolution:

  • No labels