">

Click here to check out our new How To section">Click here to check out our new How To section
Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 21 Next »

Cartridges Involved

This Configuration element involves the following Cartridges.

Note: Not all cartridges are available for all CMC models.

Exterior Overcut on Creases Definition

  • The Exterior Overcut controls where the cartridge retracts from the matboard on exterior cuts.

  • The Exterior cuts into the matboard, not the fallout.

  • The Exterior Overcut field is marked with a Red Arrow.

Current Crease Bevel Type

  • Crease

  • The Exterior Overcut is displayed on the Configuration Map and on the associated field as a red arrow.

Crease Exterior Overcut Too Long

Problem:

  • The Exterior Overcut is applied too long.

Resolution:

  • Decrease the Exterior Overcut. Adjust until the corners meet up properly.

  • When making adjustments, click the plus or minus button at the end of the desired field about five times.

  • Click OK and do another test cut.

  • Check the results of the cut and continue making adjustments until the desired outcome is achieved.

Crease Exterior Overcut Too Short

Problem:

  • The Exterior Overcut is applied too short.

Resolution:

  • Increase the Exterior Overcut. Adjust until the corners meet up properly.

  • When making adjustments, click the plus or minus button at the end of the desired field about five times.

  • Click OK and do another test cut.

  • Check the results of the cut and continue making adjustments until the desired outcome is achieved.

  • No labels