">

Click here to check out our new How To section">Click here to check out our new How To section
Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 30 Next »

Cartridges Involved

This Configuration element involves the following Cartridges.

Note: Not all cartridges are available for all CMC models.

Rotation on V-Grooves Definition

The Outside Rotation controls for Swoops or Flares on the outside cut on non-oval V-Grooves.

Because this is a V-Groove, you will be using either the Outside Rotation or the Inside Rotation, based on which V-Groove line you are editing.

  • The first cut is the interior V-Groove line and cut into the V-Groove fallout and not the matboard, and is cut in a clockwise direction. This uses the Inside Rotation.

  • The second cut is the exterior V-Groove line and cut into the matboard and not on the V-Groove fallout, and is cut in a counter-clockwise direction. This uses the Outside Rotation.

V-Groove Outside has a Swoop

Problem:

  • The Outside cut of the non-oval V-Groove has Swoops.

Resolution:

  • Decrease the Outside Rotation. Adjust until the object cuts without a Swoop.

  • When making adjustments, click the plus or minus button at the end of the desired field about four times.

  • In Rotation, eight points equals one degree of rotation. Users usually make adjustments four points at a time.

  • Click OK and do another test cut.

  • Check the results of the cut and continue making adjustments until the desired outcome is achieved.

V-Groove Outside has a Flare

Problem:

  • The Outside cut of the non-oval V-Groove has Flare.

Resolution:

  • Increase the Outside Rotation value. Adjust until the object cuts without a Swoop/Flare.

  • When making adjustments, click the plus or minus button at the end of the desired field about four times.

  • In Rotation, eight points equals one degree of rotation. Users usually make adjustments four points at a time.

  • Click OK and do another test cut.

  • Check the results of the cut and continue making adjustments until the desired outcome is achieved.

See Also: V-Groove Inside Rotation

Problem:

  • The Inside Cut of the non-oval V-Groove cuts with a Swoop/Flare.

Resolution:

See Also: Troubleshooting Utility for Non-Oval V-Grooves

Problem:

  • The Non-Oval V-Groove cuts with a Swoop/Flare.

Resolution:

  • No labels