Vertical Adjustment for Non-Blade Cartridges

Cartridges Involved

This Configuration element involves the following Cartridges.

Note: Not all cartridges are available for all CMC models.

Vertical Adjustment for Non-Blade Cartridges
Use the Vertical Adjustment if the non-blade tool (i.e., Deboss, Pen or Vinyl) is being applied to the wrong place vertically.

Select the Tool and Type
Make sure to select the desired tool from the Cartridge Tab (i.e., Deboss, Pen or Vinyl) and then the tool type you want to edit from the Current Bevel Type dropdown control (if applicable) before making adjustments.

Decrease the Vertical Adjustment to move the tool line down.
When making adjustments, click the plus or minus button at the end of the desired field about five times.
Click OK and do another test cut.
Check the results of the cut and continue making adjustments until the desired outcome is achieved.
The Tool Line will move Down.

Increase adjust the Vertical Adjustment to move the tool line up.
When making adjustments, click the plus or minus button at the end of the desired field about five times.
Click OK and do another test cut.
Check the results of the cut and continue making adjustments until the desired outcome is achieved.
The Tool Line will move up.

The opening cuts in the wrong place vertically when not cutting the outside.

Adjust the Vertical Home. If the opening is cutting in the wrong place Vertically when you are not cutting the outside of the mat, see Vertical Home.