Crease Cartridge Configurations

Cartridges Involved

This Configuration element involves the following Cartridges.

Note: Not all cartridges are available for all CMC models.

Crease Cartridge Configurations
The Crease Cartridge creases the material to make folding it easier when making Boxes.

Below is a list of support documentation for editing the configurations of the Crease Cartridge on the Crease Tab.

Crease Exterior Backup is too Long
This is viewed from the front of the mat. Select this topic to see information on editing the Exterior Backup.

Crease Exterior Backup is too Short
This is viewed from the front of the mat. Select this topic to see information on editing the Exterior Backup.

Crease Exterior Overcut is too Long
This is viewed from the front of the mat. Select this topic to see information on editing the Exterior Overcut.

Crease Exterior Overcut is too Short
This is viewed from the front of the mat. Select this topic to see information on editing the Exterior Overcut.

Crease is the Wrong Size
This is viewed from the front of the mat. Select this topic to see information on editing the Opening Adjustment.

Crease Cuts the Wrong Depth When Using a SKU
Select this topic to see information on editing the Depth Bias.

Troubleshooting Button
Select this topic to see information on editing with the Troubleshooting utility to make quick edits to the Configurations for a single object on the Cutting Preview.

Set Box Defaults
Set up the Box Defaults for the Crease cartridge in the Admin Editor section of the software.