">

Click here to check out our new How To section">Click here to check out our new How To section
Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 10 Next »

Cartridges Involved

This Configuration element involves the following Cartridges.

Note: Not all cartridges are available for all CMC models.

52 Degree Cartridge

The 52 Degree Cartridge cuts a 52° bevel into the matboard. 

Select the 52 Degree Cartridge Bevel Type

Select the desired Bevel Type from the Current Bevel Type dropdown control.

Below is a list of support documentation for editing the configurations of the 52 Degree Bevel Cartridge on the 52 Degree Tab.

Configurations for the 52 Degree Opening

Select this topic to see information on editing the configurations for the 52 Degree Opening, including:

  • Normal Bevel

  • Reverse Bevel

  • Normal Bevel-Front of Mat

  • Reverse Bevel-Front of Mat

Configurations for the 52 Degree Drop

Select this topic to see information on editing the configurations for the 52 Degree Drop, including:

  • Normal Drop

  • Reverse Drop

  • Normal Drop-Front of Mat

  • Reverse Drop-Front of Mat

Configurations for the 52 Degree Outside

Select this topic to see information on editing the configurations for the 52 Degree Outside, including:

  • Outside

  • Outside-Front of Mat

Configurations for the 52 Degree V-Groove

Select this topic to see information on editing the configurations for the 52 Degree V-Groove.

  • V-Groove

Troubleshooting Button

Select this topic to see information on the Troubleshooting utility to make quick edits to the Configurations for a single object on the Cutting Preview.

  • No labels