changes.mady.by.user dani.simmonds
Saved on Jun 04, 2024
Saved on Sept 16, 2024
Cuts are out of square and the red lines on the Drive Belt do not line up to the toothed pulley.
Fine tune the Drive Belt adjustment to square up the cuts.
For Additional Information: See also:Drive Belt Position Alignment
The most common cause for out of square opening is misalignment between the Gantry and Drive Belts.
Remove the Gantry covers by unscrewing the screws that hold it in place and set aside.
Slide the Gantry just to the right of the vertical clamp until you see the red line on the belt. It should line up with the red mark on the drive cog.
These alignment marks must align on both the top and bottom of the Gantry.
If they don’t please see Drive Belt Position Alignment.
...
Reinstall the Gantry cover(s), replacing the screws you removed earlier.
