Versions Compared

Old Version 58

changes.mady.by.user dani.simmonds

Saved on

compared with

New Version Current

changes.mady.by.user dani.simmonds

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

View file
nameDriveBeltReplacement-AllCMCs2024-0910-1607.pdf

Removing the Drive Belt

Info

  • The Drive Belt has been damaged and needs to be replaced.

  • Note: In order to preserve alignment, the Drive Belts must be replaced in pairs.

    • If you did not receive a pair of Drive Belts for replacement, please contact Wizard customer service.

  • Your hardware might look slightly different than that pictured but the pieces perform the same functions.

  • Part #:

    • 30-99000-2 Belt Assembly Kit - Rev2

  • Tools

    • Strip of matboard about ⅜” (9mm) wide and 7” (18cm) long, to help install the new belt.

    • Set of Allen wrenches

  • Remove the cover from the Gantry by unscrewing the screws that hold it in place and set aside.

Image Removed8000TakeOffHeadCoverOffLowerFSUP800.pngImage AddedGantryCoverOffHeadOnZ1UP2024800.png

  • Remove the 5/32” Allen screws and washers from the lower Gantry plate.

  • These were placed here to assist in loosening the belt tensioner.

  • Look for Red Dots (only these screws are to be adjusted).

  • Locate the 3/16” Allen belt tensioner screw that’s located on the right bottom side of the lower rail and marked with a red dot.

Warning

WARNING: Do not over-loosen this screw - one full turn is usually sufficient.

  • Loosen this screw one turn only so that there is some movement in the belt tensioner.

  • The tensioner springs should be visible.

  • Locate the belt tensioner hole on the end of the belt tensioner.

  • Place the 5/32” Allen screw and washer we removed from the lower Gantry plate into the belt tensioner hole.

  • Tighten the Allen screw until belt tensioner is flush with the rail and the springs are not visible.

  • Go back and tighten the 3/16” Allen belt tensioner screw on the right bottom side of the lower rail marked with a red dot.

  • Lift the Drive Belt end out of the belt tensioner slot.

  • Pushing the Drive Belt end to the right may assist in getting a hold of it.

  • Repeat the last six steps with the upper rail.

  • Move the Gantry to the left to loosen the slack and free the belt anchor from the end of the rail.

  • Unscrew the 1/8” Allen screw on the clamp that holds the belt to the belt anchor and remove the belt end from it.

  • Work the Drive Belt back through the Gantry wheels and remove it from the Gantry.

  • Remove the Drive Belt with the drive end still in place.

...