Overshoot on Non-Blade Cartridges | |||||||||||||||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
Contents:
|   | ||||||||||||||||||||||||
Tool Line Too Long
If the Overshoot of the Non-Blade Tool is applied Too Long, Decrease the Overshoot.
| Expand | ||
|---|---|---|
| ||
The Overshoot controls how far past the end of the Line/Arc Segment to apply the Non-Blade Tool. If the Overshoot of the Non-Blade Tool is applied Too Long, Decrease the Overshoot. This is similar to the Overcut used with the Blade cartridges. |
| Expand | ||
|---|---|---|
| ||
When adjusting Configurations, click the Plus (Increase) or Minus (Decrease) button on the desired field about five times. Click OK and do another test cut. Continue making adjustments until the desired outcome is achieved. |
Tool Line too Short
If the Overshoot of the Non-Blade Tool is applied Too Short, Increase the Overshoot.
| Expand | ||
|---|---|---|
| ||
The Overshoot controls how far past the end of the Line/Arc Segment to apply the Non-Blade Tool. If the Overshoot of the Non-Blade Tool is applied Too Short, Increase the Overshoot. This is similar to the Overcut used with the Blade cartridges. |
| Expand | ||
|---|---|---|
| ||
When adjusting Configurations, click the Plus (Increase) or Minus (Decrease) button on the desired field about five times. Click OK and do another test cut. Continue making adjustments until the desired outcome is achieved. |