Versions Compared

Old Version 44

changes.mady.by.user dani.simmonds

Saved on

compared with

New Version Current

changes.mady.by.user dani.simmonds

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

View file
nameHeadVPOFeatureAdjustmentCutTypicalMatboardZ1Z9000z90008000Plus2024HeadVPOCutTypicalMatboard-9000ZSeries8000Plus2024-0409-0817.pdf

Setting Up to Cut Typical Matboard

Info

  • Note: Decreasing the air pressure will decrease the blade depth.

Info

  • The head air regulator Head Air Regulator is located on the left side of the headHead, and controls the air pressure of the head Head as it is cutting.

  • The air pressure is applied when the head Head is cutting.

  • The minimum air pressure should be 30 psi, otherwise the blade may not cut through the matboard.

  • The maximum air pressure should be around 60 80 psi to avoid crushing the matboard.

  • FrameShop will prompt for a head Head pressure change only if the current mat is a different setting than the previously cut mat.

  • All designs come to the Cut Preview with Dense unchecked on the Cut Speeds screen.

  • Returning to the editor then going to the Cut Preview resets the layers to typical matboard with Dense unchecked.

  • Click Cut to cut the mat and Align the Head if requested.

  • The Head plunges at the home position and applies the current pressure and displays a prompt to adjust the head Head pressure to the low setting.

Image RemovedImage Added

  • Pull out the air regulator pressure knob Air Regulator Pressure Knob by pulling it to the left.

Image RemovedHeadZ1PressureKnobUP2024800.pngImage Added

  • Turn the air regulator pressure knob Air Regulator Pressure Knob counter-clockwise until the marker on the gauge is at the low setting.

Image RemovedHeadZ1ReducePressureUP2024800.pngImage Added

  • Make sure the gauge does not go below 30 psi.

Image RemovedHeadVPODialZ12024800.pngImage Added

  • Push the air regulator pressure knob Air Regulator Pressure Knob back in by pushing it to the right.

  • Click OK to cut the mat with this setting.

Image RemovedHeadZ1PressureKnobUP2024800.pngImage Added
See Also: 

No Speed Reduction

Info

  • This is a feature of the VPO Head; not all CMC models have this feature.  

  • Optionally, select No Automatic Speed Reduction for Depth of 16 and Above if you do not want the CMC to reduce speed when cutting thicker material.

  • Unselect No Automatic Speed Reduction for Depth of 16 and Above to let the CMC automatically reduce speed when cutting thicker material.

  • NOTE: Depending upon the thickness and density of the matboard, you may get better cuts by slowing down the cuts.

Info
Panel
panelIconId1f9d9-200d-2642-fe0f
panelIcon:man_mage:
panelIconText🧙‍♂️
bgColor#FFFAE6
BladeSelectDenseNoAutomaticSpeedReductionZ1-70800.png