Page Comparison

• The Vectorize Image function in Designer allows you to turn a Rastor (Image) into a Vector (Cuttable Format) to apply as a Deboss, Pen or cut in Vinyl.

The Vectorize Image function in Designer allows you to turn a Rastor (Image) into a Vector (Cuttable Format) to apply as a Deboss, Pen or cut in Vinyl.

This is simply a Raster to Vector Conversion.

Note that the Vectorizing utility in Trace has additional parameters that can be adjusted if you need more control of how an image is Vectorized.

See: Raster Definition

See: Vector Definition

See: Raster to Vector Definition

See: Vectorize in Designer Function

See: Vectorize in Trace Function

See: Raster to Vector Conversion.

See: Arc Tool in Trace

See: Arc Tool Definition /wiki/spaces/FrameShop8x/pages/1942694083

See: Splines Definition

See: Convert Arc to Splines Function

A Vector is a graphic drawing in Trace that contains Paths, which are defined by a Start and End point and may contain other Points, Curves, and Angles.

The Vector Paths are independent of resolution, which means they can be resized without losing detail.

A Path is also a file format of Trace which saves all of the Vector elements of the design as you work, whether it is Traced or not. 

When the design is completed, save it as a CutArt to load into Designer.

See: Raster Definition

See: Vector Definition

See: Raster to Vector Definition

See: Vectorize in Designer Function

See: Vectorize in Trace Function

• For Additional Information: See Vectorize in Tracefor additional Vectorization controls not contained in Designer.

CutArt™ are simple shapes and design elements created by Wizard that can be added to designs.

CutArts can be applied to your current design and edited, such as resizing and rotating.

They can be Cut, Debossed, Penned or cut on Vinyl.

See: Add CutArt Function

A Cartridge is the physical component that holds the Blade, Deboss Stylus, Pen or other application tool.

Keep Aspect Ratio (KAR) keeps the CutArt, Image, LetterMat, etc. Height and Width proportionate to avoid distortion in Designer.

See: CutArt Properties

See: Image Properties

See: LetterMat Properties

See: TTF Properties

• For Additional Information:

• See Convert to CutArt from Design to further edit the design by bringing it into the Trace program.

• See Trace Vectorize utility in Trace which has additional parameters that can be adjusted if you need more control of how the image is Vectorized.

• See Trace for information on further editing the design.