Page Comparison

Click New Mat Design on the FrameShop Main Page.

Click Cancel on the New Openings Screen.

Click on the Properties Tab and enter the outside dimensions.

Click on the Openings Tab and bring over two openings that will be the inset openings.

Now we will build up the Guides for the main opening.

Right-Click on one of the openings and select New Guide From Other.

The Add Other Guide screen will pop up.

This screen will allow you to select the Direction and the Distance from the selected openings to place a Guide.

Because I clicked on the right opening, I will select Add at Left and Add at Top.

Enter the Distance from the opening to place the Guides and click OK.

The Guides are placed.

Right-Click on the left opening and select New Guide From Other.

On the Add Other Guide screen, select Add at Right and enter the desired Distance.

• We did not select Add at Top as our top Guide has already been placed.

Click OK.

All of our Guides have been placed.

Now bring over a new opening to start the bottom-half of the inside opening.

Drag it down to the bottom to snap to the Border Line and stretch the sides of the new opening to snap against the Guides.

Bring over another opening and drag the top and sides to the Border Lines and the bottom to the Guide Line we placed.

Now drag the upper part of the bottom middle opening upwards so that it overlaps the large top opening.

Make sure the bottom opening is still selected.

Hold down the CTRL key and click on the top opening.

Both openings should now be selected.

Click on the Group Selection button.

The Openings are now merged together and our project is completed.

Using these instructions, you can great a wide variety of different designs.

.