Cartridges Involved
This Configuration element involves the following Cartridges.
| Info |
|---|
Note: Not all cartridges are available for all CMC models. |
Exterior Overcut Definition
Adjusting the Exterior Overcut
| Tip |
|---|
|
| Expand | ||
|---|---|---|
| ||
The Exterior Overcut controls where the Blade Retracts from the Matboard (not the Fallout) on the Exterior cut. |
Select the Bevel Type for the Exterior Overcut to be Edited:
Exterior Overcut on Openings
Problem:
The Exterior Overcut on Openings is cut too long or too short.
| Tip |
|---|
|
Resolution:
If the Exterior Overcut is cut too Long, Decrease the Exterior Overcut.
If the Exterior Overcut is cut too Short, Increase the Exterior Overcut.
See Exterior Overcut on Openings for additional information.
| Expand | ||
|---|---|---|
| ||
The Exterior Overcut controls where the Blade Retracts from the Matboard (not the Fallout) on the Exterior cut. |
Exterior Overcut on Drops
Problem:
The Exterior Overcut on Drops is cut too long or too short.
| Tip |
|---|
|
Resolution:
If the Exterior Overcut is cut too Long, Decrease the Exterior Overcut.
If the Exterior Overcut is cut too Short, Increase the Exterior Overcut.
See Exterior Overcut on Drops for additional information.
| Expand | ||
|---|---|---|
| ||
The Exterior Overcut controls where the Blade Retracts from the Matboard (not the Fallout) on the Exterior cut. |
Exterior Overcut on the Outside
Problem:
The Exterior Overcut for Outsides is cut too long or too short.
| Tip |
|---|
|
Resolution:
If the Exterior Overcut is cut too Long, Decrease the Exterior Overcut.
If the Exterior Overcut is cut too Short, Increase the Exterior Overcut.
See Exterior Overcut on the Outside for additional information.
| Expand | ||
|---|---|---|
| ||
The Exterior Overcut controls where the Blade Retracts from the Matboard (not the Fallout) on the Exterior cut. |
Exterior Overcut on V-Grooves
Problem:
The Exterior Overcut for V-Grooves is cut too long or too short.
| Tip |
|---|
|
Resolution:
If the Exterior Overcut on the Outside Cut of the V-Groove is cut too Long, Decrease the Exterior Overcut.
If the Exterior Overcut on the Outside Cut of the V-Groove is cut too Short, Increase the Exterior Overcut.
See Exterior Overcut on V-Grooves for additional information.
| title | V-Groove Exterior Overcut Definition |
|---|
Exterior Overcut on Creases
Problem:
The Exterior Overcut on Creases is applied too long or too short.
| Tip |
|---|
|
Resolution:
If the Exterior Overcut is cut too Long, Decrease the Exterior Overcut.
If the Exterior Overcut is cut too Short, Increase the Exterior Overcut.
See Exterior Overcut on Creases for additional information.
| Expand | ||
|---|---|---|
| ||
The Exterior Overcut controls where the blade retracts from the matboard on exterior cuts. |
Contents:
|
|