Cut the Outside On: Cut Preview Toggle | ||||
|---|---|---|---|---|
Info |
|  | ||
Cut the Outside Off: Cut Preview Toggle | |
|---|---|
|  |
Set Advanced Options: Enable Outside Cut
Optionally, the Outside cut can be turned on or off from the Advanced Outside Options: Enable Outside Cut toggle for the CMC Z1, Z(9000z), 9000 and 8000+.
Defaults: Set the Default for Cutting the Outside
| Expand | ||
|---|---|---|
| ||
The default setting for Cutting the Outside can be set in the Admin > Editor section. |
Defaults: Set the Default for 90 Degree Outside Cut
| Expand | ||
|---|---|---|
| ||
The default setting for 90 Outside Cuts can be set in the Admin > Cutting section for the CMC Z1, Z(9000z), 9000 and 8000+. Note that the CMC 8000 does support cutting with the 90 Degree Cartridge. |
Auto Offset
| Info |
|---|
|
Click on the design to select it.
Check the Auto Offset checkbox.
Enter the distance to move the design in the X Origin field; the Y Origin field uses the same numerical value.
It will move the lower left corner of the design to the new X/Y Position and it will display Dodge on the bottom of the screen.
This feature is also turned on by selecting Full from the Outside Cut Options dropdown control.
| title | Auto Offset Definition |
|---|
This is to overcome the Border Limitation of 1.25"/3.2 cm on the Cut Preview.
See: Auto Offset Setting
See: Auto Offset Default Setting
Disable Auto Offset
| Info |
|---|
|
Click on the design to select it.
Uncheck the Auto Offset checkbox.
The design will no longer be offset and will cut the design normally unless values have been entered in the X Origin and Y Origin fields as described above.
This is useful when cutting the opening from a pre-cut sheet matboard and not cutting the outside.
| title | Auto Offset Definition |
|---|
This is to overcome the Border Limitation of 1.25"/3.2 cm on the Cut Preview.
See: Auto Offset Setting
See: Auto Offset Default Setting
Defaults: Set the Default for the Auto Offset
| Expand | ||
|---|---|---|
| ||
The default setting and offset value for the Auto Offset can be set in the Admin > Cutting section. |
See Also: Options Menu: Cut Outside
| Info |
|---|
|
Click on the design to select it.
Click Options > Cut Outside to cut the outside of the mat.
It will now cut the outside of the mat.