Cartridges Involved
This Configuration element involves the following Cartridges.
| Info |
|---|
Note: Not all cartridges are available for all CMC models. |
Exterior Overcut Definition
| Expand | ||
|---|---|---|
| ||
The Exterior Overcut controls where the blade retracts from the matboard on exterior cuts. |
Adjusting the Exterior Overcut
| Tip |
|---|
|
Select the Bevel Type for the Exterior Overcut to be Edited:
Exterior Overcut on Openings
Problem:
The Exterior Overcut on Openings is cut too long or too short.
| Expand | ||
|---|---|---|
| ||
The Exterior Overcut controls where the blade retracts from the matboard on exterior cuts. |
| Tip |
|---|
|
Resolution:
If the exterior overcut is too long, decrease the Exterior Overcut.
If the exterior overcut is too short, increase the Exterior Overcut.
See Exterior Overcut on Openings for additional information.
Exterior Overcut on Drops
Problem:
The Exterior Overcut on Drops is cut too long or too short.
| Expand | ||
|---|---|---|
| ||
The Exterior Overcut controls where the blade retracts from the matboard on exterior cuts. |
| Tip |
|---|
|
Resolution:
If the exterior overcut is too long, decrease the Exterior Overcut.
If the exterior overcut is too short, increase the Exterior Overcut.
See Exterior Overcut on Drops for additional information.
Exterior Overcut on the Outside
Problem:
The Exterior Overcut for Outsides is cut too long or too short.
| Expand | ||
|---|---|---|
| ||
The Exterior Overcut controls where the blade retracts from the matboard on exterior cuts. |
| Tip |
|---|
|
Resolution:
If the exterior overcut is too long, decrease the Exterior Overcut.
If the exterior overcut is too short, increase the Exterior Overcut.
See Exterior Overcut on the Outside for additional information.
Exterior Overcut on V-Grooves
Problem:
The Exterior Overcut for V-Grooves is cut too long or too short.
| Expand | ||
|---|---|---|
| ||
The V-Groove Exterior Overcut controls where the blade retracts from the matboard on exterior cuts on the outside cut of the V-Groove. |
| Tip |
|---|
|
Resolution:
If the exterior overcut is too long, decrease the Exterior Overcut.
If the exterior overcut is too short, increase the Exterior Overcut.
See Exterior Overcut on V-Grooves for additional information.
Exterior Overcut on Creases
Problem:
The Exterior Overcut on Creases is applied too long or too short.
| Expand | ||
|---|---|---|
| ||
The Exterior Overcut controls where the blade retracts from the matboard on exterior cuts. |
| Tip |
|---|
|
Resolution:
If the exterior overcut is too long, decrease the Exterior Overcut.
If the exterior overcut is too short, increase the Exterior Overcut.
See Exterior Overcut on Creases for additional information.
Contents:
|
|