Cartridges Involved
This Configuration element involves the following Cartridges.
| Info |
|---|
Note: Not all cartridges are available for all CMC models. |
Exterior Overcut Definition
| Info |
|---|
|
Select the Bevel Type for the Exterior Overcut to be Edited:
Exterior Overcut on Openings
Problem:
The Exterior Overcut on Openings is cut too long/too short.
Resolution:
If the exterior overcut is too long, decrease the Exterior Overcut.
If the exterior overcut is too short, increase the Exterior Overcut.
See Exterior Overcut on Openings for additional information.
| Tip |
|---|
|
Exterior Overcut on Drops
Problem:
The Exterior Overcut on Drops is cut too long/too short.
Resolution:
If the exterior overcut is too long, decrease the Exterior Overcut.
If the exterior overcut is too short, increase the Exterior Overcut.
See Exterior Overcut on Drops for additional information.
| Tip |
|---|
|
Exterior Overcut on the Outside
Problem:
The Exterior Overcut for Outsides is cut too long/too short.
Resolution:
If the exterior overcut is too long, decrease the Exterior Overcut.
If the exterior overcut is too short, increase the Exterior Overcut.
See Exterior Overcut on the Outside for additional information.
| Tip |
|---|
|
Exterior Overcut on V-Grooves
Problem:
The Exterior Overcut for V-Grooves is cut too long/too short.
Resolution:
If the exterior overcut is too long, decrease the Exterior Overcut.
If the exterior overcut is too short, increase the Exterior Overcut.
See Exterior Overcut on V-Grooves for additional information.
| Tip |
|---|
|
Exterior Overcut on Creases
Problem:
The Exterior Overcut on Creases is applied too long/too short.
Resolution:
If the exterior overcut is too long, decrease the Exterior Overcut.
If the exterior overcut is too short, increase the Exterior Overcut.
See Exterior Overcut on Creases for additional information.
| Tip |
|---|
|
Contents:
|
|