Cartridges Involved
This Configuration element involves the following Cartridges.
Note: Not all cartridges are available for all CMC models.
Horizontal Home for Openings
The Horizontal Home defines the global horizontal placement of objects cut with the blade cartridges when not cutting the outside of the mat.
Opening Cuts too Far to the Right when Not Cutting the Outside: Horizontal Border too Big
Problem:
The opening is cut too far to the right Horizontally.
This is measured from the inside of the bevel to the edge of the mat.
This is viewed as it cut on the machine, i.e., from the back if cutting from the back, or from the front if cutting from the front.
Resolution:
Decrease the Horizontal Home.
The Horizontal Home defines the global horizontal placement of objects cut with the blade cartridges when not cutting the outside of the mat.
When making adjustments, click the plus or minus button at the end of the desired field about five times.
Click OK and do another test cut.
Check the results of the cut and continue making adjustments until the desired outcome is achieved.
The opening will move to the left.
Opening Cuts too Far to the Left when Not Cutting the Outside: Horizontal Border too Small
Problem:
The opening cut cut too far to the left horizontally.
This is measured from the inside of the bevel to the edge of the mat.
This is viewed as it cut on the machine, i.e., from the back if cutting from the back, or from the front if cutting from the front.
Resolution:
Increase the Horizontal home.
The Horizontal Home defines the global horizontal placement of objects cut with the blade cartridges when not cutting the outside of the mat.
When making adjustments, click the plus or minus button at the end of the desired field about five times.
Click OK and do another test cut.
Check the results of the cut and continue making adjustments until the desired outcome is achieved.
The opening will move to the right.
Horizontal Home Troubleshooting
Alternatively, adjust the Horizontal Home on the Troubleshooting Screen.
Adjusting the Horizontal Position for Non-Blade Cartridges
Contents:
|  |