Content Comparison

Cartridges Involved

This Configuration element involves the following Cartridges.

Note: Not all cartridges are available for all CMC models.

Image Removed

The Horizontal home defines the global horizontal placement of objects cut with the blade cartridges.

Image Removed

The opening is cut too far to the right Horizontally.
Adjust the Horizontal home if the opening is cutting too far to the right (as it sat on the board) when you are not cutting the outside of the mat. This is measured from the inside of the bevel to the edge of the mat.
This is viewed as it cut on the machine, i.e., from the back if cutting from the back, or from the front if cutting from the front.

Image Removed

Decrease the Horizontal home.
When making adjustments, click the plus or minus button at the end of the desired field about five times.
Click OK and do another test cut.
Check the results of the cut and continue making adjustments until the desired outcome is achieved.
The opening will move to the left.

Image Removed

The opening cut cut too far to the left horizontally.
Adjust the Horizontal home if the opening is cutting too far to the left (as it sat on the board) when you are not cutting the outside of the mat. This is measured from the inside of the bevel to the edge of the mat.
This is viewed as it cut on the machine, i.e., from the back if cutting from the back, or from the front if cutting from the front.

Image Removed

Increase the Horizontal home.
When making adjustments, click the plus or minus button at the end of the desired field about five times.
Click OK and do another test cut.
Check the results of the cut and continue making adjustments until the desired outcome is achieved.
The opening will move to the right.

Image Removed

Alternatively, adjust the Horizontal home on the Troubleshooting Screen.

Image Removed

To adjust the Horizontal placement of the non-blade cartridges, (i.e., Deboss, PenorVinyl tools), see Horizontal Adjustment.

Image Removed