Cartridges Involved
This Configuration element involves the following Cartridges.
| Info |
|---|
Note: Not all cartridges are available for all CMC models. |
Tool Configs Section | ||
|---|---|---|
| ||
|
Horizontal
Problem:
The opening/object is cut in the wrong place Horizontally.
| Expand | ||
|---|---|---|
| ||
The Horizontal Home controls where the opening is cut Horizontally. |
Resolution:
If too far left, increase the Horizontal Home.
If too far right, decrease the Horizontal Home.
See Horizontal Home for additional information.
| Info |
|---|
|
Vertical
Problem:
The opening/object is cut in the wrong place Vertically.
| Expand | ||
|---|---|---|
| ||
The Vertical Home controls specifically where the opening is cut Vertically. |
Resolution:
If too far down, increase the Vertical Home.
If too far up, decrease the Vertical Home.
See Vertical Home for additional information.
| Info |
|---|
|
Depth Bias
Problem:
The opening/object is cut at the wrong depth when a SKU has been selected.
| Expand | ||
|---|---|---|
| ||
The Depth Bias calculates the proper Blade Depth when a SKU is selected for the matboard. |
Resolution:
Cut too shallow, increase the Depth Bias.
Cut too deep, decrease the Depth Bias.
See Depth Bias for additional information.
Plunge Count
Problem:
The opening/object does not pause for a blade change while cutting.
| Expand | ||
|---|---|---|
| ||
The Plunge Count controls the number of plunges for the individual blade cartridges to pause for a Blade Change. |
Resolution:
If cuts too long before pausing, decrease the Plunge Count.
If cuts too short before pausing, increase the Plunge Count.
See Plunge Count for additional information.
Circle/Oval Rotation Button
Problem:
The Circle/Oval cuts with a Feather/Bump.
| Expand | ||
|---|---|---|
| ||
The oval cuts with a Feather of material left into the opening. The Circle/Oval Rotation controls for Bumps or Feathers on an Oval Opening. |
| title | Bump Definition |
|---|
The oval cuts with a Bump of material left into the opening.
The Circle/Oval Rotation controls for Bumps or Featherson an Oval Opening.Resolution:
If cuts with a Feather, decrease the Oval Rotation.
If it cuts with a Bump, increase the Oval Rotation.
See Circle/Oval Rotation Utility for additional information.
See Oval Rotation for additional information.
Contents:
|  |