Page Comparison

Pull the Vacuum Gate Button to raise the mat alignment pins on the cutting surface.

Lay the matboard to be cut against the alignment pins.

Take care to NOT hit the Cut Button while the alignment pins are still activated on the cutting surface, as they will damage the footblock when it tries to cut.

When you are ready to cut, press the Vacuum Gate Button in before pressing the Cut button to retract the alignment pins behind the cutting surface.

Once the design has been set up in the software and the matboard has been set in place, the user can push the Green Push-to-Cut Button on the Control Panel to cut the mat.

Optionally, you can click the Cut button on the Cut Preview Screen.

If the Push-to-Cut Button is pressed during operation, the CMC will pause.

Pressing it again will cause the CMC to continue where it left off.

CAUTION: Make sure that the Vacuum Gate Button has been pushed in first to retract the Alignment Pins from the cutting surface.

The Emergency Stop Button (red button) on the Control Panel can be pushed at any time to immediately abort the current cut.

To restart after hitting the Emergency Stop Button, twist the Emergency Stop Button in the direction of the arrows to release the Emergency Stop Button; it will pop back up.

Go to the Control Unit and cycle the power by clicking the On/Off green rocker switch off and then back on again.

Wait approximately three seconds then push the green Reset push-button on the Control Unit.

Return to the FrameShop software and click the Reset Motors button and let the Eclipse reset itself and find the Home position.

When it has finished, you will be ready to start the next project.