Cartridges Involved
This Configuration element involves the following Cartridges.
| Info |
|---|
Note: Not all cartridges are available for all CMC models. |
Tool Configs Section | ||
|---|---|---|
| ||
|
Horizontal
Problem:
The opening/object is cut in the wrong place Horizontally.
Resolution:
If too far left, increase the Horizontal Home.
If too far right, decrease the Horizontal Home.
See Horizontal Home for additional information.
| Info |
|---|
|
Vertical
Problem:
The opening/object is cut in the wrong place Vertically.
Resolution:
If too far down, increase the Vertical Home.
If too far up, decrease the Vertical Home.
See Vertical Home for additional information.
| Info |
|---|
|
Depth Bias
Problem:
The opening/object is cut at the wrong depth when a SKU has been selected.
Resolution:
Cut too shallow, increase the Depth Bias.
Cut too deep, decrease the Depth Bias.
See Depth Bias for additional information.
Plunge Count
Problem:
The opening/object does not pause for a blade change while cutting.
Resolution:
If cuts too long before pausing, decrease the Plunge Count.
If cuts too short before pausing, increase the Plunge Count.
See Plunge Count for additional information.
Circle/Oval Rotation Button
Problem:
The Circle/Oval cuts with a Feather/Bump.
Resolution:
If cuts with a Feather, decrease the Oval Rotation.
If it cuts with a Bump, increase the Oval Rotation.
See Circle/Oval Rotation Utility for additional information.
See Oval Rotation for additional information.
Contents:
|  |