Versions Compared

Version Old Version 14 New Version Current
Changes made by

dani.simmonds

dani.simmonds

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

Cut the Outside as a Shared Edge

  • Select Shared Edge from the Outside Cut Options dropdown control to cut the shared edges of the outside cuts

on the CMC Z1 and Z (9000z).    ExpandtitleShared Edge Definition

  • .  

  • The Shared Edge function will cut the Shared Edges of the Tiled Outside Cuts on the CMC Z1

and

  • , Z(9000z), 9000 and 8000+ as one stroke between the designs, instead of cutting the outside of each mat individually. 

Image Removed
Image Added

  • When Tiling, make sure that the Spacing under the Setup Tab is set to Zero (0) so that each design shares the Outside lines with the next design, so it will only cut the single line between them. 

  • If you have Remnant Trimming on, it will also cut off the scrap edge.

Expandtitle

    • Remnant Trimming

DefinitionRemnant Trimming

    • feature trims off the remaining portion of the mat Horizontally or Vertically after cutting the design to make storing the leftovers easier.

Image Removed

Advanced Outside Options

Info
Image Removed
Image Removed

  • The Shared Outside edges of the Tiled design will cut in one stroke. 

  • If you have Remnant Trimming on, it will also cut off the scrap edge.

Expand
titleRemnant Trimming Definition

Remnant Trimming feature trims off the remaining portion of the mat Horizontally or Vertically after cutting the design to make storing the leftovers easier.

Image Removed

Defaults: Set the Default for Cutting the Outside 

Expand
titleDefault Setting for Cutting the Outside

The default setting for Cutting the Outside can be set in the Admin > Editor section.

Image Removed

Defaults: Set the Default for 90 Degree Outside Cut

Expand
titleDefault Setting for 90 Degree Outside Cut

The default setting for 90 Degree Outside can be set in the Admin > Cutting section.

Image Removed

Defaults: Set the Default for the Advanced Options

Expand
titleDefault Setting for the Default Advanced Options

The default setting for the Advanced Options can be set in the Admin > Cutting section.

Image Removed

Defaults: Set the Default for the Cut Mode

Expand
titleDefault Setting for Default Cut Mode

The default setting for the Cut Mode can be set in the Admin > Cutting section.

Image Removed
Image Added

Default Settings