Content Comparison

Click the Align the Head button to Align the Head into the cutting position and power up the motors in preparation of cutting a mat.

Optionally, if you click the Cut button when the motors are disengaged, it will prompt you to Align the Head.

After the Head is Aligned, itwill then Cut the mat.

The CMC will do an Interference Check to see if any of the clamps are in the way of the current cut sequence.

Rotate the indicated clamps as described below and click Continue.

To rotate the Clamp out of the way, push the indicated clamp toward the

Board to release the pressure.

Rotate the indicated

Clamps so that they are facing away from the center of the

Board.

When the Clamps are engaged, they will be retracted flush with the

Board.

For the next cutting job, the

Clamps should be rotated back toward the center of the

Board to hold down the next mat.

Rotate the

Footblock into the 12 O’Clock position.

Holding it about an inch above the bottom rail, slide the

Gantry and the

Head assembly to the left edge of the CMC until it stops. 

It will stop against the Magnetic Stop.

Then slide the

Head down until the

Footblock rests against the Head Alignment Stop.

Click the Align the Head button or the Cut button to finish the Align the Head sequence.

On the Alignment screen, make sure that the Pen, Vinyl and Creasing tools are not in the

Footblock.

Click Continue on the Alignment screen.

Head will align to the

Home position.

If you clicked the Align the Head button, the CMC is now

Aligned and ready to cut.

If you clicked the Cut button, the CMC will now begin to cut the mat.