Versions Compared

Old Version 1

changes.mady.by.user dani.simmonds

Saved on

compared with

New Version 2

changes.mady.by.user dani.simmonds

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

Level the Camera

To achieve consistent measurements via the software, it is essential that the camera be level with the design table surface. If the camera is not level, the software may not measure accurately.

Moving or Disturbing the Camera

Calibration must be repeated whenever the camera is moved, or if the mounting stand or camera are bumped, potentially knocking it off level.

Image Added

Set Up and Level Camera

To achieve consistent measurements via the software, it is essential that the camera is level and parallel with the design table surface. If the camera is not level, the software will not measure accurately.

Install the camera on camera mount (pole or ceiling).  


NOTE: If you are mounting the computer monitors to the countertop camera pole, please do so prior to attaching and leveling the camera.

Image Added

Use a small level on the horizontal and vertical planes of the camera to set up the level of the camera.  

Image Added

Use the side thumb screw to adjust the level of the camera and lock it into position.

...