Content Comparison

Outside Cut Options

Use the Outside Cut Options dropdown control to select several setting that dictate how the outside of the mat is cut on the CMC 9000z.

For the outside cut options for a non-CMC 9000z, see Cut the Outside.

Select the desired outside cut option from the Outside Cut Options dropdown control.

The setting selected for the outside cut will be used on the next mat cut.

...

Set the Cut Mode under the Set Advanced Options to select how the outside cut will be cut.

Optionally, click Set Advanced Options to access the Advanced Outside Cut Options.

Set the desired Cut Mode to select how the outside cut will be cut. These match the Outside Cut Options described above.

The selected Cut Mode will be used until a different option is selected.

Set the Default for Cutting the Outside
The default setting for Cutting the Outside can be set in the Admin > Editor section.

Set the Default for 90 Degree Outside Cut
The default setting for 90 Degree Outside can be set in the Admin > Cutting section.

Set the Default for the Advanced Options
The default setting for the Advanced Options can be set in the Admin > Cutting section.

Set the Default for the Cut Mode
The default setting for the Cut Mode can be set in the Admin > Cutting section.

...

Disabling the Auto Clamp Offset will now cut the designs normally without being offset up and over on the mat.

Uncheck the Auto Clamp Offset checkbox.

The design will no longer be offset on the CMC 9000z and cut the design normally.

Set the Default for the Enable Auto Clamp Offset
The default setting for the Enable Auto Clamp Offset can be set in the Admin > Cutting section.