Cautions | |
|---|---|
NEVER SKIP AHEAD ON ANY STEP! Head appearance may vary from model shown, but the connections are the same. Never pull/push on the drive shaft to move the gantry. Use the gantry arm to move/pick up the gantry. | |
Do not pick up the head using only the blade depth knob or the head cover. Pick up the head by holding the “D-Shaped” upper and lower head plates. | |
...
Head Removal | |
|---|---|
Click reset motors button on the cut preview and click OK on the release motors prompt. | |
Push blade cartridge release down to eject the blade cartridge. Turn off the air. | |
Remove the hood from the gantry by unscrewing the screws that holds it in place and set aside. | |
Move the gantry to the right side of the board until the foot block is off the board. | |
Disconnect the head power plug (square connection) from the head grabber arm. | |
Disconnect the air to the head by untwisting the two air fittings. | |
Remove the two 5/32” screws and set aside. | |
Roll the head down the gantry until it rolls off the gantry, taking care not to drop it. | |
Gantry Removal |
|---|
NEVER SKIP AHEAD ON ANY STEP! |
Remove Stop Screws | |
|---|---|
Remove the front right 3/16” stop screw from the alignment plate on the left bottom rail (located on the top of the bottom rail) and set aside. | |
Loosen the back left screw and T-Nut and slide the alignment plate to the end of the rail to remove. If your model only has a stop screw without the alignment plate, remove the stop screw. | |
Remove the 5/32” Allen screws and washers from the lower gantry plate. | |
Disconnect Gantry | |
|---|---|
Disconnect the air lines to the gantry by untwisting the air fittings. Disconnect the board cable by turning the locking ring until it comes away from the gantry. | |