Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

Cautions

NEVER SKIP AHEAD ON ANY STEP!

Head appearance may vary from model shown, but the connections are the same.

Never pull/push on the drive shaft to move the gantry. Use the gantry arm to move/pick up the gantry.

Image Added

Do not pick up the head using only the blade depth knob or the head cover. Pick up the head by holding the “D-Shaped” upper and lower head plates.

Image Added

Straight Line Trimmer Removal

Follow these instructions if you have a Straight Line Trimmer installed, otherwise skip ahead to “Head Removal”.

Turn the shut off valve on the Blue Air Line, and unplug the Blue Air Line before removing the Straight Line Trimmer.

Image Added

Turn the bottom locking knob Clockwise to loosen.

Image Added

Turn the top locking knob Counter-Clockwise to loosen.

Slide the Straight Line Trimmer off of the Board and set aside in a safe place.

Image Added

Head Removal

Click reset motors button on the cut preview and click OK on the release motors prompt.

Image Added

Push blade cartridge release down to eject the blade cartridge. Turn off the air.

Image Added

Remove the hood from the gantry by unscrewing the screws that holds it in place and set aside.

Image Added

Move the gantry to the right side of the board until the foot block is off the board.

Image Added

Disconnect the head power plug (square connection) from the head grabber arm.

Image Added

Disconnect the air to the head by untwisting the two air fittings.

Image Added

Remove the two 5/32” screws and set aside.

Image Added

Roll the head down the gantry until it rolls off the gantry, taking care not to drop it.

Image Added