...
Deboss Size too Small | |
|---|---|
The Deboss is too small. |  |
Increase the Deboss Opening Adjustment. |  |
When making adjustments, click either the minus or plus or minus button (-/+) at the end of the desired field about five or six times in the direction indicated. Click OK OK and do another a test cut. Check the results of the cut and continue making adjustments until the desired outcome is achieved. |  |
Deboss Size too Big | |
|---|---|
The Deboss is too big. |  |
Decrease the Deboss Opening Adjustment. | |
When making adjustments, click either the minus or plus or minus button (-/+) at the end of the desired field about five or six times in the direction indicated. Click OK OK and do another a test cut. Check the results of the cut and continue making adjustments until the desired outcome is achieved. | |
Opening Adjustment in the Troubleshooting Screen | |
|---|---|
Alternatively, adjust the Opening Adjustment in the Troubleshooting Screen by entering the measured height and width of the tool line into the appropriate fields and clicking the Calc Opening Adjustment button. Make sure that only the Deboss is present on the screen, otherwise the Troubleshooting Button will be grayed out. |   |