...
Current Drop Bevel Type | |
|---|---|
Select the desired Cartridge Tab and then the bevel type you want to edit from the Current Bevel Type dropdown control before making adjustments. Select Current Bevel Type-Front of Mat if it is being cut from the front of the mat.
|  |
Drop Size tooSmallBig | |
|---|---|
The drop is cutting too smallbig. |   |
Increase the Decrease the Opening Adjustment. |   |
The object will now be the correct size. |  |
When making adjustments, click either the minus or plus button (-/+) at the end of the desired field about five or six times in the direction indicated. Click OK and do a test cut. Check the results of the cut and continue making adjustments until the desired outcome is achieved. |  |
Drop Size tooBigSmall | |
|---|---|
The drop is cutting too bigsmall. | |
Decrease the Increase the Opening Adjustment. | |
The object will now be the correct size. | |
When making adjustments, click either the minus or plus button (-/+) at the end of the desired field about five or six times in the direction indicated. Click OK and do a test cut. Check the results of the cut and continue making adjustments until the desired outcome is achieved. | |
Opening Adjustment in the Troubleshooting Screen | |
|---|---|
Alternatively, adjust the Opening Adjustment in the Troubleshooting Screen by entering the measured height and width of the drop into the appropriate fields and clicking the Calc Opening Adjustment button. Make sure that only the drop is present on the screen, otherwise the Troubleshooting Button will be grayed out. |   |