...
Compare the Last Mat Cut to the Configuration Map | |
|---|---|
Look at the front of the last mat you have cut, in the same orientation in which it was cut. Use the Configuration Map to determine the problem area. |  |
In this example, compare the lines that are too long to the lines on the Configuration Map. |  |
These long lines are the Exterior Backups, which are displayed on the Configuration Map as Green Arrows. |  |
Decrease the Exterior Backup in the Configurations by a couple of clicks, click OK, and do a test cut. Adjust until you get the desired result.  |  |
When making adjustments, click either the minus or plus button (-/+) at the end of the desired field about five or six times in the direction indicated. Click OK and do a test cut. Check the results of the cut and continue making adjustments until the desired outcome is achieved. |  |