Oval Rotation on Outside | |
|---|---|
The Oval Rotation field controls how much the foot block will rotate before cutting. Adjust the Oval Rotationif you are getting Bumpsor Featherson an oval outside. If you have too much rotation on an oval outside, you will get a Feather, too little and you will get a Bump. |   |
Current Bevel Type | |
|---|---|
Select the desired Cartridge Type Tab and then the bevel type you want to edit from the Current Bevel Type dropdown control before making adjustments. Select Current Bevel Type-Front of Mat if it is being cut from the front of the mat. |   |
Degrees of Rotation for Oval Openings | |
|---|---|
In Oval Rotation, eight points equals one degree of rotation. Users usually make adjustments 4 points at a time. |   |
Increase the Oval Rotation to turn the foot block clockwise to correct for a Bump. Decrease the Oval Rotation to turn the foot block counterclockwise to correct for a Feather. |  |
Oval Outside has a Bump | |
|---|---|
The blade returns to the outside of the starting point of an oval outside cut, creating a bump in the oval. |   |
Increase the Oval Rotation. |   |
When making adjustments, click the plus or minus button at the end of the desired field about five times. Click OK and do another test cut. Check the results of the cut and continue making adjustments until the desired outcome is achieved. |   |
Oval Outside has a Feather | |
|---|---|
The blade returns to the inside of the starting point of an oval outside cut, creating a feather in the oval. |   |
Decrease the Oval Rotation. | |
When making adjustments, click the plus or minus button at the end of the desired field about five times. Click OK and do another test cut. Check the results of the cut and continue making adjustments until the desired outcome is achieved. | |
Circle/Oval Rotation Utility | |
|---|---|
Optionally, use the Circle/Oval Rotation Utility to fine-tune specific sizes of circles/ovals. |  |