...
Layers | |
|---|---|
Layers Enter the number of Layers. Enter the reveal value for each layer. Select Reverse Bevel if desired. |
Set the Default Number of Layers | |
|---|---|
Set the default setting for the number of layers in the Admin > Editor section. | |
Set the Default Reveal Value | |
|---|---|
Set the default Reveal Value in the Admin > Defaults section. | |
Cartridge Selection | |
|---|---|
Click on the Cartridge Icon and select the desired cartridge for this layer. Note that not all cartridges are available in all scenarios. For instance, you cannot select the Deboss Cartridge for a template from the New Openings Screen. You would need to take the design into the Editor, create a Deboss opening, then select a template shape for it on the Properties Tab. | |
Bring Design into the Editor | |
|---|---|
Click OK to bring the design to the Editor to finish editing. Alternatively, click Cut to go straight to the Cutting Preview. | |
Creating an Array within the EditorAlternatively, you can create an array while in the Editor. | ||
|---|---|---|
| 1 | Creating an Array within the Editor Alternatively, you can create an array within the Editor by Right-Clicking on one of the Template Slots. | |
| 2 | The Array screen opens. Enter the sizes and the layout as desired. Click OK to place the openings on the Editor. | |