Versions Compared

Version Old Version 28 New Version Current
Changes made by

dani.simmonds

dani.simmonds

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.
Panel
panelIconIdatlassian-plus
panelIcon:plus:
panelIconText:plus:
bgColor#FFFAE6

  • The Air Regulator controls the primary air pressure for the CMC and helps control the pressure for the Clamps, Head Plunge, Blade Plunge and Blade Depth.It usually sits at

Info

Usage:

  • The Air Regulator pressure is usually set around 60-70 psi.

    • It is set at the factory and does not need adjusting.

  • The Air Regulator is self releasing when the Air Compressor is turned off.

  • Check the Air Regulator at least once a week for any buildup of moisture or oil.

Tip

Connections:

  • The Air Regulator is connected between the Boardand the Air Compressor.

Warning

Troubleshooting:

  • Q: If the matboard is being pushed aside when you try to cut because the Air Clamps are not inflating:

    • A: Make sure that the Air Compressor is on.

  • Q: When you first turn on your Air Compressor, you may hear air escaping from the Air Regulator.

    • A: It will do this until it builds up enough pressure and will seal itself off.

...