Page Comparison

Placing Matboard When Cutting from the Back

Info
When the Cut Preview screen indicates that the current layer is to be cut from the Back of the mat, this also determines how to place the matboard onto the CMC.

Panel

panelIconId	1f9d9-200d-2642-fe0f
panelIcon	:man_mage:
panelIconText	🧙‍♂️
bgColor	#FFFAE6

For Additional Information:
See Options > Switch Between Front and Normal Tools on the Cut Preview.
See Options > Always use Normal Tool on the Cut Previewto toggle on/off this feature.
See Options > Cut From Front on the Cut Previewto select whether to cut the design from the Front of the mat.
See Options > Cut Front Tool on the Cut Previewto designate which cartridge to use when cutting from the front of the mat.
Select Cut From Front toggle to select whether to cut the design from the Front of the mat on the Cut Preview.

Tip
Default Settings: Cut from Front: Cutting Default Setting

Have Two Layers of adequate size of disposable matboard under the Mat to be Cut; a Layer can be temporarily removed when cutting thicker matboard.
Place the matboard into the left corner of the CMC, making sure that the matboard nestles tightly into the Horizontal and Vertical Clamps.

Expand

title	Cut From the Back Definition

Cutting from the Back will cut with the back of the mat toward the operator, and can be selected on the Cut Preview.

On the Configurations screen the Current Bevel Type dropdown control will display the bevel types in this manner:
- Cut from the Back bevel type names will be displayed with no further label; i.e., Normal Bevel.
- Cut from the Front bevel type names will be displayed with a Front label; i.e., Normal Bevel-Front of Mat.
- V-Grooves have their own selection on the list.

If you are cutting an element that must be applied to the front of the mat, such as a V-Groove or Pen design, any openings on that layer will also cut from the front and use the Front of Mat configuration item; i.e., Normal Bevel-Front of Mat.

So if you are having problems with a Normal Bevel cut on the same layer as a V-Groove, make sure you select Normal Bevel-Front of Mat to edit the configurations for that opening.