The Shared Edge function will cut the Shared Edges of the Tiled Outside Cuts on the CMC Z1, Z(9000z), 9000 and 8000+ as one stroke between the designs, instead of cutting the outside of each mat individually.
When Tiling, make sure that the Spacing under the Setup Tab is set to Zero (0) so that each design shares the Outside lines with the next design, so it will only cut the single line between them.
If you have Remnant Trimming on, it will also cut off the scrap edge.
Remnant Trimming feature trims off the remaining portion of the mat Horizontally or Vertically after cutting the design to make storing the leftovers easier.
