Page Comparison

• Select the desired Remnant Trimming direction on the CMC Z1, Z (9000z), 9000 and 8000+ from the Remnant Trimming dropdown control. This will trim off the remaining section of the matboard to make it easier to store the remaining pieces for future use.   

• For Additional Information:

• See Matboard Properties in the Design to turn on/off the Outside cut.

• Select Options Menu > Cut Outside on the Cut Previewto cut the outside of the mat.

• See /wiki/spaces/FrameShop8x/pages/1942506497 on the Cut Previewto turn on/off the Outside cut.

• See Enable Outside Cutunder Advanced Outside Options on the Cut Previewto toggle on/off the Outside cut.

• See Cut Outside Using 90 Degree Tool under Set Advanced Optionson the Cut Preview.

• See Cut Mode in the Set Advanced Options section on the Cut Preview.

• See Shared Edge for the Cut Mode in the Set Advanced Options section on the Cut Preview.

• See Full for the Cut Mode in the Set Advanced Options section on the Cut Preview.

• See As Designed for the Cut Mode in the Set Advanced Options section on the Cut Preview.

• Default Settings:

• See Admin > Editor for the default settings for Cutting the Outside.

• See Admin > Cutting for the default settings for the Advanced Options.

• See Admin > Cutting for the default settings for the Cut Mode.

• See Admin > Cutting for the default settings for 90 Degree Outside.

• See Admin > Cutting for the default settings for Tiling.

• See Admin > Cutting for the default size for the Spacing between designs.

• See Admin > Cutting for the default settings for Remnant Trimming.Cut the Outside: Editor Default Setting

• Advanced Outside Settings: Cutting Default Setting

• Cut Mode: Cutting Default Setting

• 90 Degree Outside: Cutting Default Setting

• Tiling Defaults: Cutting Default Setting

• Sheet Size: Cutting Default Setting

• Tiling Spacing: Cutting Default Setting

• Remnant Trimming: Cutting Default Setting

Remnant Trimming feature trims off the remaining portion of the mat Horizontally or Vertically after cutting the design to make storing the leftovers easier.

See: Remnant Trimming Function

Remnant Trimming feature trims off the remaining portion of the mat Horizontally or Vertically after cutting the design to make storing the leftovers easier.

See: Remnant Trimming Function