Page Comparison

• Use the Cut the Outside checkbox to select whether or not to Cut the Outside of the mat.

  • This can also be changed on the Cut Preview.

• When Cut the Outside is selected, the matboard displays as a Solid Color.

• Unchecking Cut the Outside displays the 1.5 inch (3.8cm) Uncuttable Region in a checkerboard pattern. The uncuttable region is the portion of the matboard that is placed into the CMC rails when cutting. 

• The Z1 and Z(9000z) will not display an uncuttable region because of the Zero Waste clamping system, unless the matboard dimensions entered are larger than the machine can physically cut (see Uncuttable Region).

• Do not place objects into the uncuttable region unless you select Cut the Outside or use the Auto Offset.

• For Additional Information:

• Select Options Menu > Cut Outside on the Cut Previewto cut the outside of the mat.

• See /wiki/spaces/FrameShop8x/pages/1942506497 on the Cut Previewto turn on/off the Outside cut.

• See Enable Outside Cutunder Advanced Outside Options on the Cut Previewto toggle on/off the Outside cut.

• See Cut Outside Using 90 Degree Tool under Set Advanced Optionson the Cut Preview.

• See Cut Mode in the Set Advanced Options section on the Cut Preview.

• See Remnant Trimming in the Set Advanced Options section on the Cut Preview.

• Default Settings: Cut the Outside: Editor Default Setting

The Auto Offset moves the design up and over on the Cut Preview to avoid the Clamparea.

This is to overcome the Border Limitation of 1.25"/3.2 cm on the Cut Preview.

See: Auto Offset Setting

See: Auto Offset Definition

See: Auto Offset Default Setting