changes.mady.by.user dani.simmonds
Saved on May 08, 2024
Saved on Sept 27, 2024
Select Full from the Outside Cut Options dropdown control to cut the complete outside edge of the design on the CMC Z1, Z(9000z), 9000 and 8000+.
When Tiling mats, it will cut out the complete outside edge of each design.
If you have Remnant Trimming on, it will also cut off the scrap edge.
For Additional Information:
See Matboard Properties in the Design to turn on/off the Outside cut.
Select Options Menu > Cut Outside on the Cut Previewto cut the outside of the mat.
See Cut the Outside /wiki/spaces/FrameShop8x/pages/1942506497 on the Cut Previewto turn on/off the Outside cut.
See Enable Outside Cutunder Advanced Outside Options on the Cut Previewto toggle on/off the Outside cut.
See Remnant Trimming in the Set Advanced Options section on the Cut Preview.
Default Settings:
See Admin > Editor for the default settings for Cutting the Outside.
See Admin > Cutting for the default settings for the Advanced Options.
See Admin > Cutting for the default settings for the Cut Mode.
See Admin > Cutting for the default settings for 90 Degree Outside.
See Admin > Cutting for the default settings for Remnant Trimming.Full Cut Mode: Cutting Default Setting
Remnant Trimming: Cutting Default Setting
Remnant Trimming feature trims off the remaining portion of the mat Horizontally or Vertically after cutting the design to make storing the leftovers easier.
See: Remnant Trimming Function
