Interior Overcut on V-Grooves | |||||||||||||||||||||||||||||
---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
|
V-Groove Cut Direction and Cut Order
Tip |
---|
|
Tip |
---|
|
V-Groove Interior Overcut too Long
If the Interior Overcut on the Inside Cut of the V-Groove is cut Too Long, Decrease the Interior Overcut on V-Grooves.
Panel | ||||||||
---|---|---|---|---|---|---|---|---|
| ||||||||
|
Expand | ||
---|---|---|
| ||
The V-Groove Interior Overcut controls where the Blade Retracts from the Fallout (not the Matboard) on the Interior cuts of the Inside Cut of the V-Groove. The Interior Cut is where the Blade Plunges or Retracts from the Fallout (not the Matboard). If the Interior Overcut on the Inside Cut of the V-Groove is cut Too Long, Decrease the Interior Overcut on V-Grooves. The V-Groove Interior Overcut field is marked with a White Arrow on the Configurations screen and the Map illustration. |
Expand | ||
---|---|---|
| ||
When adjusting Configurations, click the Plus (Increase) or Minus (Decrease) button on the desired field about five times. Click OK and do another test cut. Continue making adjustments until the desired outcome is achieved. |
V-Groove Interior Overcut too Short
Panel | ||||||||
---|---|---|---|---|---|---|---|---|
| ||||||||
|
If the Interior Overcut on the Inside Cut of the V-Groove is cut Too Short, Increase the Interior Overcut on V-Grooves.
Expand | ||
---|---|---|
| ||
The V-Groove Interior Overcut controls where the Blade Retracts from the Fallout (not the Matboard) on the Interior cuts of the Inside Cut of the V-Groove. The Interior Cut is where the Blade Plunges or Retracts from the Fallout (not the Matboard). If the Interior Overcut on the Inside Cut of the V-Groove is cut Too Short, Increase the Interior Overcut on V-Grooves. The V-Groove Interior Overcut field is marked with a White Arrow on the Configurations screen and the Map/wiki/spaces/FrameShop8x/pages/1942503207illustration. |
Expand | ||
---|---|---|
| ||
When adjusting Configurations, click the Plus (Increase) or Minus (Decrease) button on the desired field about five times. Click OK and do another test cut. Continue making adjustments until the desired outcome is achieved. |