Versions Compared

Old Version 1

changes.mady.by.user dani.simmonds

Saved on

compared with

New Version Current

changes.mady.by.user dani.simmonds

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

How to Make a Tucked Corner Design Using the #613: Fr Stair Top

Info

  • This These instructions will walk you through using show you how to Merge two #613: Fr Stair Top designs and merging them openings together to create a single design.

Panel
panelIconId1f9d9-200d-2642-fe0f
panelIcon:man_mage:
panelIconText🧙‍♂️
bgColor#FFFAE6
TuckedCornerDone800.png

  • Click New Mat Design on the FrameShop Main Page.

  • Click Cancel on the New Openings Screen.

  • On the Openings Tab, bring two template #613: Fr Stair Top onto the Editor.

Info

  • NOTE: Selecting different Templates and adjusting their Parameters will give you an unlimited range of creative options.

TuckedCornerStart800.png

  • Click on the Properties Tab to edit it.

  • Enter the desired size for the two #613: Fr Stair Top openings.

    • Remember that we are going to merge the two templates together so keep that in mind when sizing the design.

TuckedCornerSize800.png

  • Click on the Parameters Tab.

  • Change the # Notches to 3 for each opening.

TuckedCornerParams800.png

  • Click on the Bottom #613: Fr Stair Top opening.

  • In the Rotation field, enter 90 for the degree of Rotation.

  • The #613: Fr Stair Top will be rotated 90°.

TuckedCornerRotate800.png

  • Move each of the #613: Fr Stair Top openings into the center of the mat.

TuckedCornerCenter800.png

  • Select both openings and click the Group Selection button.

TuckedCornerMerge800.png

  • The two openings should merge where they overlapped.

  • If you need to make an adjustment to the design, click the Group Selection button to unmerge them, then click on the background to unselect them.

  • Re-edit as desired and then regroup them again.

TuckedCornerMerged800.png

  • The edited Tucked Corner design is now completed.

Info

NOTES:

  • You can repeat this process to merge any two templates together in any fashion as long as they share the same Bevel Type.

  • Try different degrees of Rotation.

  • Experiment with using different sized Templates.

  • Try using different Templates.

  • You can also adjust the Template’s Parameters which will give you endless creative options for your creative abilities.

  • Remember: Have fun!

TuckedCornerDone800.png