Page Comparison

View file

name	HeadVPOCutTypicalMatboard-9000ZSeries8000Plus2024-0506-2407.pdf

Setting Up to Cut Typical Matboard

Info
Note: Decreasing the air pressure will decrease the blade depth.

Info
The head air regulator Head Air Regulator is located on the left side of the headHead, and controls the air pressure of the head Head as it is cutting. The air pressure is applied when the head Head is cutting. The minimum air pressure should be 30 psi, otherwise the blade may not cut through the matboard. The maximum air pressure should be around 60 psi to avoid crushing the matboard.

FrameShop will prompt for a head Head pressure change only if the current mat is a different setting than the previously cut mat.
All designs come to the Cut Preview with Dense unchecked on the Cut Speeds screen.
Returning to the editor then going to the Cut Preview resets the layers to typical matboard with Dense unchecked.

The Head plunges at the home position and applies the current pressure and displays a prompt to adjust the head Head pressure to the low setting.

Pull out the air regulator pressure knob Air Regulator Pressure Knob by pulling it to the left.

Turn the air regulator pressure knob Air Regulator Pressure Knob counter-clockwise until the marker on the gauge is at the low setting.

Push the air regulator pressure knob Air Regulator Pressure Knob back in by pushing it to the right.
Click OK to cut the mat with this setting.

Info
This is a feature of the VPO Head; not all CMC models have this feature.

Optionally, select No Automatic Speed Reduction for Depth of 16 and Above if you do not want the CMC to reduce speed when cutting thicker material.
Unselect No Automatic Speed Reduction for Depth of 16 and Above to let the CMC automatically reduce speed when cutting thicker material.
NOTE: Depending upon the thickness and density of the matboard, you may get better cuts by slowing down the cuts.

Panel