changes.mady.by.user dani.simmonds
Saved on May 15, 2024
Saved on May 29, 2024
If the Overcut is Too Long, Decrease the Overcut.
If the Overcut is Too Short, Increase the Overcut.
For Additional Information: See Using the Backup and Overcut Display on the Cut Preview for Troubleshooting.
Select desired Cartridge Tab.
Select the desired Bevel Type from Current Bevel Type.
Edit the desired Configuration field.
When adjusting Configurations, click the Plus (Increase) or Minus (Decrease) button on the desired field about five times.
Click OK and do another test cut.
Continue making adjustments until the desired outcome is achieved.
The Overcut controls where the cartridgeRetracts from the Matboard.
If the Overcut is cut Too Long, Decrease the Overcut.
If the Overcut is cut Too Short, Increase the Overcut.
The Overcut field is marked with a Red Arrow on the Configuration screen and the Mapillustration.
See: Overcut for Creases Configurations