Page Comparison

• The large red button in the center of the panel is the E-Stop button. Its purpose is to stop the machine in case of an emergency, such as loading the board wrong. If the button has been pressed, turn it in the direction of the arrow to turn it off. The machine will not run until the E-Stop is released.

• The Clamp switch is located on the right side of the e-stop button. Its purpose is to raise and lower the clamps that hold the matboard in place.

• The last switch is the power switch. This will turn all power off to the machine as well as the computer. The computer has an outlet for it on the machine. The power switch is located on the opposite side of the clamp switch.

• Glides along the mat being cut.

• When changing the Blade, loosen the Brass Thumb Screw, slide out the old Blade, and replace with a fresh Blade. Hold the Blade toward the right while tightening the Brass Thumb Screw to ensure it is in the correct position.

• Holds the Blade secure to the Cutting Foot. Loosen to replace the Blade, tighten to hold into place.

• The Blade Clamp is positioned between the Blade and the Brass Thumb Screw, and holds the Blade secure and in position.

Loosen the two screws on the top and push the Blade Depth Adjuster:

• to the Left for 2 ply,

• to the Center for 4 ply,

• to the Right for 8 ply.

• Retighten the two screws on the top to hold the Blade Depth Adjuster in place.

• When cutting a V-Groove, push the V-Groove Adjuster to the Left. Keep the V-Groove Adjuster to the Right when cutting openings.

With the Blade Depth Adjuster set to the center, adjust the Blade Depth Adjustment to go through 4-ply.

• Turn the Blade Depth Adjustment Screw CW for a shallow cut.

• Turn the Blade Depth Adjustment Screw CCW for a deeper cut.