Page Comparison

The Driver Pack is the signal amplifier to the Wizard CMC and comes in several variations.

Remove the old parts before installing the replacement parts, and return the old parts to Wizard for proper credit.

It is important to note that if you are replacing a USB Driver Pack with a USB 80-Volt USB Driver Pack (label on the back will state if it is an 80-Volt Driver Pack), to follow the instructions “Installing the Drivers for the 80-Volt Driver Pack” at the end of this document.

Connect the Driver Pack to the computer by plugging the USB Cable into the USB Driver Pack.

If you were sent a replacement USB Cable, plug the new USB Cable into the Driver Pack, and the other end into the same USB Port that the old cable was using.

Plug the Power Cable into the back of the Driver Pack.

Before plugging in the Board Cable (large grey), note that several of these pins are in a straight line.

Align the plug so that the pins are aligned correctly, gently insert plug, then turn black Locking Ring until it seats itself and clicks into place.

The replacement USB Driver Pack has been installed.

If you are replacing a USB Driver Pack with an 80-Volt Driver Pack, follow the directions under “Installing the Drivers for the 80-Volt Driver Pack”.

Power on the Driver Pack by flipping the toggle on the back to “1”).